Home > News > Content
Curtain rod installation sequence
Jun 15, 2018

The curtain rod of the bridge that builds for beautiful curtain, when installing, very pay attention to, look at the installation steps of the curtain rod below:


1. Ready to install items, including: the hammer drill and supporting Φ 6 mm drill bit, steel tape, pencil, cross screwdriver, Φ 6 mm plastic expansion tubes, Φ 4 x40mm self tapping


2. Check the fitting of Roman poles and their decorative heads, supports and rings, measure the length of Roman rods and the width of Windows


3. Draw the support positioning line and hole position line with the installed support as the standard line. Generally, the length of the Roman pole is more than 2.5m. The middle support is located in the center of the window or wall, and the two ends should be equidistant. The supports at both ends leave the wall about 15-20cm or 5-10cm from the end of the Roman pole (ceiling).


4. The depth of drilling is 3.5-5cm, and the hole cannot run or tilt when drilling. Note: stay away from power lines and water pipes. After drilling, press the plastic expansion pipe into the hole.


5. Install the rod


The support is tightened with self-tapping wire, and the lifting ring is put into the rod. The lifting ring is divided into two parts, with one hanging ring at each end. Press the Roman pole into the open support and adjust so that both ends of the decorative head leave the wall at the same distance.


6. Hang the curtain and hook the curtain, and hang the other end of the hook into the hole of the hanging ring; Left and right open and close the curtain, check whether sliding is flexible, whether two curtains are equal height. Otherwise, fine tuning.


Previous: No Information

Next: What Is Curtain Rod